Hold Codes
What is this?
When a shipment is unable to continue moving, a condition is reported.
The hold reason code is displayed in the TRAIN/BO/HLD column in the Location
and ETA output formats.
In the Equipment or Reference output view, a red exclamation mark will
appear next to the Equipment ID if there is a delay. The reason for delay
will appear if you hold your mouse over the red exclamation mark.
When is it used?
The primary causes of a hold condition are:
- insufficient information to move the shipment to destination
- held at customer's request, either from the shipper or the receiver
- a railway caused condition
If you believe the hold condition to be incorrect you should contact
a Customer Support Representative.
The following codes are used:
| Code |
Long Code |
Description |
| CC |
Customs Hold |
Customs Clearance |
| CH |
Customer Hold |
Equipment in Customer Hold status, awaiting steamship release |
| CW |
Accident |
Equipment in wrecked Train (derailment) |
| DI |
Disposition |
Disposition, awaiting customer instructions |
| EM |
Embargo |
Embargo, shipment cannot proceed via its original route. Awaiting
additional instructions from customer |
| HI |
Heating/Cooling |
Heating Inspection, including service for Refrigeration
equipment |
| LI |
Lading Inspect |
Lading Inspection for load-shift or Dimensional measurement |
| MI |
Mechanical |
Mechanical Inspection |
| NB |
Bill of Lading |
No Bill, awaiting original shipping instructions |
| OC |
Congestion |
Operating Conditions |
| OT |
Other |
Other |
| WG |
Weighing |
Weighing, shipment held until scaled |
|
Quick Trace Help
